Maximum strength permanent spray adhesive engineered to withstand heat, stress, and moisture.

ExtremeGrip High-Strength High-Temperature Multipurpose Adhesive is built for maximum strength and long-term durability in demanding conditions. Engineered to withstand heat up to 240°F, moisture, and mechanical stress, it provides a permanent bond suitable for both indoor, outdoor and marine environments. Its high shear and peel strength make it ideal for marine, automotive, construction, and high-pressure lamination applications where reliability cannot be compromised. With a solvent-based, ultra-low VOC formula, this sprayable adhesive delivers fast tack, excellent versatility, and consistent performance across a wide range of substrates.

Key Features

Up to 2.5x Stronger
-40°F to 240°F Service Temperature
Marine and Outdoor Use
Permanent Bond
Sprayable
Withstands humid, damp, and wet conditions
Fast Tack
Flexible Bond
Low Odor
Versatile
Solvent-Based Formula
MEK Free
Methylene Chloride Free
Made in the USA

Adheres to

Foam
Fabric
Particle Board
Wood
Metal
Fiberglass
Insulation
Carpets
Plastic
Paper
Cardboard
Low Energy Plastics
FRP (Fiber-Reinforced Plastic)
Laminates
Rubber
SBR Rubber
Gel Coat
Polyethylene
Polypropylene

Recommended Applications/Uses

Indoor & Outdoor Use
High-Temperature Environments
High-Moisture Environments
Marine Manufacturing & Flooring
Outdoor Flooring & Carpeting
Automotive Headliners & Trim
Cabinets & Woodworking
Automotive & Construction Panels
High-Pressure Lamination
Laminate Postforming
And more!

Safety & Compliance

VOC Compliant for CA & OTC
HAPs Free
No Ozone Depleting Substances
No CFCs
No Chlorinated Solvents

Directions
For best results surfaces must be clean, dry, and free of dust. Wipe with ExtremeGrip Cleaner Thinner, lightly sand with 180-grit, then wipe again with ExtremeGrip Cleaner Thinner. Keep temperatures above 40°F and allow to dry before applying. Spray smooth, even coats (≥2 g/ft²), using two coats on porous materials like fabric, foam, or wood. Allow 2-4 minutes for drying, then join surfaces applying firm pressure for full contact. If clogging occurs while spraying, clean tip & valve with ExtremeGrip Cleaner Thinner.

Storage
Store sealed in a cool, dry place (55–80°F). Do not exceed 120°F. Shelf life begins at manufacture date when stored properly.

Performance may vary by application. Always test adhesives under your specific conditions to ensure suitability.

General Adhesives

CushionCraft Heavy Duty Foam & Fabric Adhesive

Weldwood Contact Adhesive

Rochford ExtremeGrip Vinyl Cement+

ExtremeGrip® Vinyl Cement

ExtremeGrip® High-Strength High-Temperature Multipurpose Adhesive

ExtremeGrip® Cleaner Thinner

ExtremeGrip® Multipurpose Adhesive